Bathtub stains are annoying. They don’t only make the tub look dirty but they also make the fixture look completely unappealing. Unfortunately, stains are among the most common and in fact, inevitable bathtub issues that you’ll encounter. With constant cleaning and maintaining, you should be able to keep your tub stain-free. Here are some cleaning tips that may come in handy!
1. To clean porcelain tubs, you can use cleaners or abrasive powders like Ajax. Just pour some of the powder on the affected area (stained area) on the bathtub and then add only a little water.
2. Get a scouring pad and use its green side to scrub the stained spots.
3. If the stain is too stubborn, get a pumice stone and use that instead. But remember, you must be certain that your bathtub is porcelain. Otherwise, the pumice stone may damage it or even tarnish its surface.
4. Get a small bowl and make a paste by combining the abrasive powder and some water. Apply this paste on the bathtub and let it stay there for about 15 to 30 minutes. Afterward, scrub the area and wash with tap water.
1. Acrylic tubs require more cleaning than enamel or porcelain tubs. It is advised to clean this kind of tub at least once a week with the use of a soft sponge and mild detergent or dishwashing liquid. Take note that you can’t use cleaning pads or abrasive scrubs on acrylic bathtubs.
2. If you see any spot on the tub where there’s a buildup of hard water mineral deposits, you can use a vinegar and water solution. Combine some water and vinegar and put the solution in a spray bottle. Spray it on the area where there are a lot of sediments. Let the solution sit for approximately 45 minutes. Once the time is up, scrub the area with soft sponge and then rinse it with tap water.
3. Here’s another tip: never use pumice stones and scouring pads on acrylic tubs. They will tarnish the surface of the tub.
4. Lastly, never wax acrylic tubs.
1. You may use commercial cleaners for enamel bathtubs. Just guarantee that the cleaner you’ll use don’t have harsh chemical content or bleach. The bleach will react with the tub and create stains that look like rust.
2. Mild cleaners are better to use. If you don’t have one, you can make use of your shampoo. Just rub a small amount onto the dirty area in the tub and let it sit for a few minutes. Wash with tap water only.
3. If you ever notice soap scum, grease or dirt in the tub, the application of trisodium phosphate will be enough to loosen these substances. Combine a tablespoon of this material with a gallon of hot (but not boiling) water. Take note that you should never combine it with any other kind of detergent or cleaner.
4. Another way to clean enamel tubs is through the use baking soda and hydrogen peroxide. Create a past out of these two ingredients. Apply it onto the stained area and leave it alone for about 1 hour. As usual, wash with tap water.
We hope that you learned how to clean bathtub properly through our blog today. Also read our article on how to deep clean a shower to keep your shower area clean and bacteria-free. Anyway, if you need help with bathtub installation, just call the most reliable local plumbers in the US. Plumbers 911 provides trusted emergency plumbing services in the US including bathroom remodeling services in the US, plumbing fixture installation in the US, water heater repair services in the US, toilet repair services in the US and many more! Call us at Miami (305) 662-0668, Fort Lauderdale (954) 468-0512, West Palm Beach (561) 327-6287, Washington DC (877) 932-5325, Boston (855) 550-9911, Missouri (816) 326-8643 or Kansas (816) 326-8643 to schedule a service now!
Meanwhile, learn about our awesome plumbing services in Kansas! Watch our video below.